The house as it looked on the morning of truss day. It had rained hard the night before. All fingers were crossed that today would be a dry day. |
Upstairs, Ross continued a mopping up operation that had begun in the wee hours of the morning. |
Another view of the safety meeting. In this view, left to right, Daniel, Ross, Dave, the BB, and Mike. |
Jake joined the meeting. |
Tim, a subcontractor brought on board for the truss operation, joins Mike in setting up the scaffolding that the crew will walk on as they move the trusses into place. |
Susan, Maya, and Zoe climbed up the ladder to visit with us in the dining room while we waited for the truck with the trusses. |
Dave shows Isaac, Zoe, Larkin, and Maya some of the tools of the trade. |
Still waiting for the trusses. |
Mike joins us as we continue to wait for the trusses. |
By this time, the adults were getting annoyed that the trusses were late. The kids seemed not to mind as Laura led them on a raspberry picking adventure. |
By 12:30, the trusses arrived, but the gallery had left because small kids need lunch and naps. Too bad, but there will be many other big trucks before our remodel is over. |
Ditto |
Ditto. Tim helps muscle the plywood package into a safe spot. |
There are two sizes of trusses. The shorter trusses are for the addition, the longer trusses for the main part of the house. The truck unloaded the shorter trusses first. |
Lifting the short trusses into a standing position on the top of the wall plates. The crew then tacked 2x4s onto the trusses to hold them in place. |
Daniel, Dave, and Casey, all wearing safety gear, await the main house trusses. |
The main house truss package comes off the truck upside down, so it needs, first, to be dropped to the ground, where it can be lifted tothe house in an upright position |
Ditto |
The main house trusses are on the way. |
Ditto |
Ditto |
Daniel tacks 2x4 braces on the truss stack to hold it in place. |
The first truss, now fully clad in plywood, is lifted into place by Mike and Tim. |
It's a house! |
Mike and Tim carry truss #4 into place. The trusses are spaced 2' apart. It is amazing how quickly the crew had the trusses in place. |
Ditto |
All of the main house trusses are now in place. |
Tim and Daniel are cladding the rear-most truss in plywood. |
This photo was taken moments before the start of the installation of trusses on the addition. |
The BB watches the first truss on the addition slide into place. |
2x4s projecting from the ends of the roof gables begin the framing of the front eaves. Around the entire perimeter of the house, the eaves will project 2 1/2 feet. |
Mike and Tim begin nailing fascia boards to the projected eaves on the east side of the house. |
Ditto. In this photo, Tim is using one of the miracle tools of the construction industry, a nailing gun, operated by compressed air. |
In this photo, Mike uses one of the oldest tools of the construction industry to drive a final nail into this fascia board. |
The first fascia board to be attached to the projecting gable on the front of the house. |
In this photo, Mike lifts a 4x8 sheet of plywood up through the trusses and begins to install the layer of sub roofing plywood on top of the roof. |
This photo, taken moments before our departure from Bellingham for a 10-day visit to California, shows the first couple of plywood sections lying on the roof. |
Before we left, we visited with our neighbor, Mary. In this photo, the BB shows Mary the view from her future office. |
Our ceilings in bags. Seems to be the story of this old house! |
Ditto |
Zoe and Maya standing at the bottom of what will become the stairs to the second floor. They are looking up at their Mom, who has climbed up the ladder. |
Ditto. |
Sue took this photo of one of the new rectangular skylights awaiting installation. |
At the end of the week, this is the rear of the house showing the fascia boards and trim on the rear gable fully installed. |